You are reading a single comment by @bluehuw and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
bluehuw
Any thoughts on this bench top pillar drill? There is one near me for ~£150.
3-16mm strikes me as a good range of hole sizes. And I assume 300 to 2250rpm covers most materials.
Is 30kg heavy as these things go?
Cheers.
https://www.clarketooling.co.uk/product/cdp152b-bench-drill-press-230v/
Chuck Capacity 3-16mm (spindle taper B16) / Includes drilling depth gauge
12 Speeds from 300 to 2250rpm
230V 450W induction motor
203x195mm table size with +/- 45O tilting angle
Table can be swivelled a full 360O allowing the base to be used as a work support.
Chuck to table: 11-355mm, Chuck to column: 130mm, Chuck to base: 460mm
Dimensions (LxWxH): 515mm x 292mm x 830mm, Weight: 27.6kg