You are reading a single comment by @hugo7 and its replies. Click here to read the full conversation.
  • Hi @mcmyk Idk if you'd be able to suggest something. The metal the machine screws screw into is now a bit fucked and rusted away. As a result the bottom two screws holding on the back panel don't bite.

    Would it be safe to use something like a bit of jb weld to build it back up to give the screw something to bit into?

    The proper solution I guess is a nut+washer+bolt but that means removing the oven again, and sourcing the bits. Whereas I have jb weld and can reach into the oven without removing it.


    1 Attachment

    • IMG_20230720_143030505~2.jpg
  • If our service techs encounter a stripped screw in the field on thin sheet metal they drill it out to 4mm and put a pop rivet in

About

Avatar for hugo7 @hugo7 started