Home DIY

You are reading a single comment by @Chaley and its replies. Click here to read the full conversation.

•

rhb

Fuse replaced at switch we have power to boiler again. F7 error code which is

F7 Flame detected even though appliance switched off. Check electrode assembly, dry pcb. Flue clear?

Is it within the realm of diy to get the pcb out and dry it above our dehumidifier then safely refit it? I can isolate the power, obvs.

•

Chaley in reply to @rhb

As long as you’re not touching the gas side, I say go for it.

•

rhb in reply to @Chaley

We got the dehumidifier under it & F7 is now C1 (weak fan) so I think I'm out of diy'ing it back to life.

About

Avatar for Chaley @Chaley started