You are reading a single comment by @Overuser155208 and its replies.
Click here to read the full conversation.
-
Take them out and measure them (or, if you're lucky, read the dimensions off the side)
-
Put a straight edge across the face of the head tube and the top of the bearing race will be below it, fit spacer to fill the void, put back together play is gone. Or fit the original conical top, which I’m sure you don’t have.
99% sure that’s the answer
gbj_tester
Chaley
@Overuser155208
Anyone know what these bearings could be
3 Attachments