You are reading a single comment by @stelfox and its replies.
Click here to read the full conversation.
-
Those are some sharp peepers, it is, but Im holding on to it for sentemental reasons.
The ox601's are awesome! I bought them for all the reasons you started. My one complaint is the pre-tension bolt used a 5mm hex and is made of cheese. It stripped (threads re fine) so I had to drill two holes so you can use a pin wrench to get it in and out. Very annoying. Otherwise fantastic, considereing selling them also but they fall into the sentemental catagory, so we will see.
Ph1ll1p
@stelfox
Is that a nitto ui-12 stem in the drop bar pic? Dibs pending length if you are selling
Those ox601 cranks are bloody expensive too, one of the very very few low Q factor, 24mm axle cranks you can put a sub-compact (and smaller) on