You are reading a single comment by @midlife and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
midlife
niclas
About to remove an old bottom bracket, and need some advice before I make things worse.. :)
My Park tools pin spanner almost fits. It has 2,9mm pins and it fit a bit too tight to the holes, their other pin tool seem to be for 2,3mm which seem too small.
Would carefully drilling the hole to 3,0mm be a way to go in this scenario? The bottom bracket is in quite a rough conditions, and I will most likely replace it once removed.