You are reading a single comment by @Tenderloin and its replies.
Click here to read the full conversation.
-
Hah! hook friends. Needs a flat wall and screws only protruding the barest minimum amount. 100% movement free on two of mine so it is possible, but the third in our bullshit porch is against some awful lumpy paint render finish thing and just slumps sadly. It was improved after relentless fettling but not as good as the others.
-
A bag of glazing shims/packers and a Stanley knife.
Likely 1 and 2 mm ones meticulously cut in half so they sit along the bottom edge of the shelf to even out any bumps in wall and maybe sit too high but sag level when shelf is loaded
6pt
Mr_Smyth
@Tenderloin
https://verygoodandproper.co.uk/shop/products/rail-system-1200mm
I’m trying to fit one of these to a wall - it has the hidden screws at the rear which should line up and slide on tight. I’ve lined everything up with a laser but it doesn’t fit right/flush and leans forward when stuff is hung on it. I think this is because the wall isn’t dead flat but I’m not sure what the answer is.