You are reading a single comment by @scultura and its replies.
Click here to read the full conversation.
scultura-
Sorry, I don't understand. Could you rephrase?
The axle is inserted from the NDS, as I recall. There are some little silver "washers" that go on after the bearings and before the axle. Grease the axle lightly, slide in all the way and then use the preload cap on the drive side and I just tightened it hand tight, and then did up the little hex grub screw. Then it's end caps pushed on to the axle on each side (and finally disc brake rotor in my case).
hazzelfrazzel
I just replaced bearings on a fulcrum front wheel last week so can confirm that's the right bearing. I got them from here for slightly cheaper, but not much https://www.wychbearings.co.uk/MR-18307-LLB-ABEC5-Enduro.html