You are reading a single comment by @stevo_com and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
stevo_com
I need to cut an elliptical hole for a 32mm waste pipe to pass through a wooden wall panel at a 45 degree angle - does anyone know, is this doable with a holesaw and an in situ jig (ie some bits of wood)? Is there an established method for this?
Or should I just cut slightly larger round holes and fill the gaps?