Wheelbuilding / Wheel Building / Wheel build help

You are reading a single comment by @M_V and its replies. Click here to read the full conversation.

•

snottyotter in reply to @M_V

take a full spoke of known length, put two of them in opposing holes on the rim and screw nipples down to where you'd want them to end up and then use a caliper to measure between the bends as per this image and add that to 2 x the spoke length

I do this.

•

M_V in reply to @snottyotter

The "screw the nipples down to where you want them" bit, spoke end flush with the top of the nipple?

•

withered_preacher in reply to @M_V

Same here
•

snottyotter in reply to @M_V

Yeah.

About

Avatar for M_V @M_V started