You are reading a single comment by @Rik_Van_Looy and its replies.
Click here to read the full conversation.
-
I did something similar to this on mine knotted an elastic band, passed it through the cable entry hole and then slipped it between the clamp and bars to secure.
I'd go for something elasticated just in case you absent mindedly do 2-handed braking!
Previously I did the same as @kjlem but with the bit from inside a choc block electrical connector (replacing the cap-heads with socket screws)
this worked fine till I grabbed the brakes then it moved a little bit and introduced a buzz
Rik_Van_Looy
I also think you could use a bit of elastic cord and a cord-lock toggle. Put the toggle inside the lever body and pass the cord through to the lever blade; tie a knot and have this sit where the inner cable pear-shaped end thing would be.