You are reading a single comment by @Rik_Van_Looy and its replies.
Click here to read the full conversation.
-
Thanks, that's a good place to start - looks like that's the fusion edge 12 now, looks like they're landing in the £10-20k range which is more than I can just whack on the company card!
From there, I'm now looking at the Flux Beamo and FSL Muse Core.
In our lab at the mo, we've got a Raise 3D for FDM - this is working well for us and adding value so I'm looking for something at a similar level
Rik_Van_Looy
We have an Epilog Zing at work which I've used a bit. The software is easy enough and it handles 4mm ply in a single pass. I've found the zero positioning a bit fiddly, and there don't seem to be any limit switches to stop the motors running the gantry into the end of the rails. They have updated all their systems now though, so maybe they fixed a few of the niggles. I expect it is quite an expensive system though.