For Sale: Slam that stem - low stack headset cover

You could also try a compression ring with a lower stack like this:

Yes, I have deeper ones. Take measurements as shown in the first post to see what size you need.

try a compression ring with a lower stack

Looking at his picture, since the bearing is about 1mm out of the frame I'm guessing the compression ring is the standard 2mm above the bearing. There might be something to be had in that area, but I'm not sure.

Thank you will take a look and yes you've said it here better than I would have but that was my conclusion too!

looking for a 46mm x 2mm stack cover, i believe those are the dims for a supersix.
in stock ?

Yes, they're in stock, can't say for sure whether that's the right size for your Supersix but I have the right size for it whatever it is 🙂

thanks, i will double check dimensions, regardless of bike model

have sent an enquiry the website but no reply, should i pm ?

should i pm ?

Yes, it looks like your enquiry got lost in either the ether or the spam filter

@gbj_tester do you have any 46mm x 3mm covers?

The distance from the compression ring to the top of the headtube is 4mm. I think i've got my calculations right.

You really want a 46×4 and a shim between the cover and the compression ring, a whole mm of gap is ugly. I have both in stock

Lovely, ta. Let me re measure in the cold (warm) light of day tomorrow morning and I'll get back to you.

As expected, I measured poorly last night. The actual depth is 3mm from the compression ring to the top of the head tube.
Do you have the appropriate cover in stock?

Do you have the appropriate cover in stock?

Yes, you'll want a 46×3. If it's exactly 3mm when the compression ring is compressed, you'll still need to hunt through your parts bin for a shim

Lovely, i'll buy one of those then. Would the shim be a 1 1/8 shim to sit on top of the cover?

Would the shim be a 1 1/8 shim to sit on top of the cover?

You're probably going to need one between the compression ring and the cover
https://www.edinburghbicycle.com/fsa-micro-spacer

Hello, I'm looking for one of these headset covers that'll fit a CAAD 5 - does anyone know the dimensions?

does anyone know the dimensions?

We could guess, but it's best to measure