You are reading a single comment by @Mr_Smyth and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Mr_Smyth
Airhead
Not sure stain is the correct product? The last wood stain I used left a coating on the wood which would've made it unsuitable for oiling.
Wood dye (Liberon do some) might be a better bet.
As for filling the gaps, you'll likely end up with a pine floor with stripes down it? It might look alright, but probably not any better than just leaving them as they are.
Would some pine strip wood cut (should be doable with a sharp knife) to fit and glued in work? Again, would probably be a ballache.
If you're oiling them, look at Fiddes oils as they come in a load of different colours, which might save you the hassle of dying them first.
5ml samples for one pound summat.
https://www.ebay.co.uk/itm/284836875736
I think one of the Osmo Polyx tinted oils we used on one floor turned out quite orangey/red, could've been the honey, or amber one.