You are reading a single comment by @Airhead and its replies.
Click here to read the full conversation.
-
drop out of suspension pretty quickly
That is a common problem with primers. I usually stir the tin really well and then put a small amount in a painters pot where I can stir it a bit with the brush as I'm going along.
Sometimes after an undercoat you can very lightly hand sand some of the 'fluff' you can see there off.
Airhead
rhowe
Applied some fine surface filler, sanded back and applied a first coat of primer (valspar stuff I had knocking about. It's got a reasonable amount of solids I think, but they drop out of suspension pretty quickly so you have to keep stirring.
Hopefully this will look ok after a light sand.