You are reading a single comment by @ugosantalucia and its replies.
Click here to read the full conversation.
-
What I mean is that if the inter-flange distance is too short, then the hub is only suitable for deep rims… anything shorter than say 54-55 mm is not really suitable for shallow rims
ugosantalucia-
Ah, I was going in the other direction, that a very large diameter (relative to the ERD) or widely spaced flange could exceed the permitted approach angle of the spoke to the rim, which would facilitate precession of the threads under cyclic loading due to asymmetric support under the spoke head. Your idea sounds good too 🙂
gbj_tester
Pray expand, just in case you mean something other than what I think you mean.