-
Kinda rare to break these, an SKS mantel plate will fit (60mm wide I think), just drill out the old rivets and rivet new one in.
As for your gear shift, if you set it on the line and then it misbehaves in both direction = cable issue, or the actuator on outside of hub is full of crud or not fitted properly.
Must have a kink or some damage somewhere. If you remove old cable, measure the end of the outer to the metal nut with a caliper, tighten caliper and leave it set aside for when you thread it back together, think its something like 86.5mm but its hub dependent (shimano tech docs will tell you) -
Dude, the slack chain and the quality of the chain is highly concerning. If you can't (no judgement) make it right yourself definitely fine someone who can.
You are reading a single comment by @dubkev and its replies.
Click here to read the full conversation.
BrickMan
bright
@dubkev
Arrgh.. just noticed one of my mudguard arm clips is snapped. It was definitely fine before I brought it to Besbike.
1 Attachment