You are reading a single comment by @stevo_com and its replies.
Click here to read the full conversation.
-
Nerve racking though if your using expensive materials!
I'll move to the DIY thread after this. While they only provide just enough trim material, it should be wide enough that I get two cracks at it (my gaps are smaller than expected). Even if that does fuck up, it will be painted so I can just switch to MDF.
stevo_com
Polygon
This is good advise for sure!
With scribing, would practice on some offcuts first of your process, then, stick to the process!
Recently did the worlds most wonky room, floor, walls, everything all over the shop and managed to get the skirting all lined up nice on top and a very consistent 1-2mm gap all around over top of engineered wood floor. Nerve racking though if your using expensive materials!