Mechanics and Fixing Any Questions Answered

You are reading a single comment by @Brommers and its replies. Click here to read the full conversation.

•

atz

Integrated bars and stems with internal routing... how the fuck am I supposed to get di2 cables around some of those bends? Should I just use a vacuum cleaner to suck some thread down through the right holes?

•

Brommers in reply to @atz

I used to use a combination of thread, wires, spokes, welding wire magnets and spoke nipples. These days I mostly use the Park magnetic kit for internal routing.

•

atz in reply to @Brommers

I've done a couple of frames before, but the angles on the integrated bars is giving me the shits. I'll start with thread and see where I end up.

About

Avatar for Brommers @Brommers started