You are reading a single comment by @seager and its replies.
Click here to read the full conversation.
-
i use this
-
Soldering iron is my favoured method, though I guess you could heat up a screwdriver for the same effect
-
I use the pointy bit of a large safety pin, heated to cherry red heat on a gas hob, with a bit of woggling to make the hole roughly the right size. Works for me.
-
Nothing is foolproof but if you're not using a hammer you're doing it wrong
amey
BareNecessities
Brommers
hippy
@seager
Is there a fool proof way to make the valve hole in tubeless rim tape? Think I've been living life with a slow leak from there (replaced the valve).