You are reading a single comment by @ian(conker) and its replies. Click here to read the full conversation.
  • There is adjustment available for chain tensioning with the vertical drop.

    Before sizing a new chain- you need to loosen (don’t remove!) these three screws, and wind out the grub screw (which I’ve pointed to but you can’t see. Repeat this on the other side too. Give the wheel a sharp kick and the whole thing should rock forward, pivoting on that top screw. When it’s as far forward as possible then you size the chain. tension by winding the grub screws back in evenly checking the wheel is staying centre.

    Make sure these 6 screws are nice and tight before setting off because it will f you up if they’re not!

    Lots of shops / people who aren’t familiar with these bikes don’t reset the wheel position when sizing the chain, so there literally isn’t enough adjustment to get good tension.

  • Didn't know that. There's no room to move wheel forward without tyre rubbing on mudguard but could probably have moved it back to tighten the chain. Anyway the chain tensioner works really well

About

Avatar for ian(conker) @ian(conker) started