You are reading a single comment by @Jung and its replies.
Click here to read the full conversation.
-
At least you are getting to learn standing up in a workshop. I learnt on my back under a Renault 4 :)
-
Armchair critique. That's some solid beading right there. Looks like proper penetration. Proper home madness that. Again, you still haven't told me what the fuck that car that's dying in the corner is?
@DethBeard Glad to hear you rolled through it enough to function and get the insurance bullshit sorted. Salute.
Airhead
Chak
@Jung
Latest garage addition. A cheap slip roll - makes far more replicable tubes and cones than I can by bending the sheet over a mandrel. Requires a bit of fiddling for cones that I need to get the hang of but it’s already an exponential improvement. Did a test piece yesterday and this is with zero manipulation post cuts…far easier to weld.
3 Attachments