-
https://www.youtube.com/watch?v=hSjU6HPO-0s
If its taper edge, the tapered edges are super easy to get a good finish with only basic tools (scrim, easyfil 60, sand pad, jointing knife, tunes), for butt joints a little trickier to get a good finish. But if its a garage and your not fussed just scrim tape it, and run over it once. IDeally you'd run over the butt joints 2 or 3 times, each time leveling out over a larger area, then sand in until its invisible to anyone normal.
Screw heads, make sure they are in, cut any paper sticking out the holes, light sand, fill over with easyfil, sand a few hours later, paint.UK is obsessed with just skimming plaster over absolutely everything, if you get your boards level and in good shape you don't need to do this, and I'm pretty anal about finish.
You are reading a single comment by @Dammit and its replies.
Click here to read the full conversation.
BrickMan
@Dammit
I'm stupendously lazy, is there a tape (flashing tape?) suitable for covering the joints in the plasterboards which make up the ceiling in my garage, which will cover the screws and the gap and I can then just paint over? I don't care that it would be visible under the paint.