Tool library / tool exchange. Post what you got and where you are

You are reading a single comment by @jdmitch and its replies. Click here to read the full conversation.

•

ectoplasmosis in reply to @jdmitch

Removing the bore cap does not adjust anything. You’ll only end up with fluid everywhere.

As @MCamb says, try pushing the pistons back in.

•

jdmitch in reply to @ectoplasmosis

I've pushed them back as far as I can but there's still not enough clearance for the pads... I am obviously doing something wrong but haven't found any videos or anything with close enough detail to see how I should be putting them in (and is it specific to the hope mono mini or is this a general issue?)
Update: this video answered my questions/uncertainty about what was going on:
https://youtu.be/mJahubHxYZ8

•

MCamb in reply to @jdmitch

Sometimes you can’t push the pistons in when there’s too much fluid in the system… have you tried letting some out?

About

Avatar for jdmitch @jdmitch started