You are reading a single comment by @pdlouche and its replies.
Click here to read the full conversation.
-
Time for a block skim and raised compression ;)
-
That’s cool! Remember, increasing the bore raises the compression ratio anyway, worth calculating what it will be. Also, I always measure piston to bore clearance just to check the hone job is good.
Get the head looked at when you have it apart too, valve seats and maybe a little gas flow? Should rip!
lynx
Jung
@pdlouche
Something arrived for the DR350…..
(400cc/82mm ATV kit: cylinder, piston, pin, rings, gaskets… pushes to 376cc)
1 Attachment