You are reading a single comment by @Acliff and its replies.
Click here to read the full conversation.
-
It’s also an odd shape, as the utility room is narrower on one side, so the worktop needs to be 90cm depth on the left edge, 65cm depth on the other edge, with a cutout to the left rear for boiler and UFH pipes.
I suppose I could use cheaper ply as a test and use as a template for a more expensive solution later.
Acliff
That's not that big. I'd probably grab a sheet of ply from a DIY place that does cutting and then screw and glue a couple of bits together. Sand the edges and paint with something.
How much action is it going to see?