You are reading a single comment by @Polygon and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Polygon
I have a faced plywood which I need to bend where the inside of the curved piece will be visible.
Can I cut kerfs and bend in the opposite direction, then perhaps fill the gaps with a 2 part epoxy filler? I would rather not have to build a box to steam.
approx. 75cm length and the curve is from a circle with maybe 3m radius, so not too much of a bend.