You are reading a single comment by @carson and its replies.
Click here to read the full conversation.
-
Ah thanks so much for this and also doing the maths. I had a bit of a time trying to measure but I think it's 52 so a normal hub (I think you did a typo) so I just need end caps. Annoying but not as bad as rebuilding a wheel.
Moral of the story is buy and use Vernier callipers.
Interesting that you can convert a boost hub to 142.. didn't realise that. I thought it was a negative shim situation.
Belagerent
@carson
...if your measurement between the flanges is 57 you have a hub that was built as a boost hub - if it's 52mm then its a 142mm hub - either way, it looks like you can make it fit your dropouts by using the appropriate conversion kit.