Audiophiles hifi appreciation thread old and new

You are reading a single comment by @BigH and its replies. Click here to read the full conversation.

•

Dogtemple in reply to @BigH

It’s pretty simple job, there’s plenty of machinists out there that would do it. I’ve got a metal lathe but no time right now, would knock a couple up for you otherwise

•

BigH in reply to @Dogtemple

Wouldn't know who to specifically ask for such a small job, a hobbyist is prob the best bet. I would happily pay you if you did find some time to do them. I would give it a go myself if I had access to a metal lathe tbh!

•

moocher in reply to @BigH

Do you have the measurements? I could make one, but might not be for a couple of weeks.

About

Avatar for BigH @BigH started