Any question answered...

You are reading a single comment by @wenzovic and its replies. Click here to read the full conversation.

•

Dammit

Can you get a fine feeler gauge into the gap between the lock ring and the rotor spider?

•

wenzovic in reply to @Dammit

There's no gap with the lockring installed and tightened.

•

gbj_tester in reply to @wenzovic

no gap

No gap just means it's touching, not necessarily pressing. Measure the thickness (A) of the rotor centre and the depth (B) from the face of the hub shell to the face of the shoulder. You'll want about 0.5mm difference to allow the lockring to press on the rotor properly before bottoming out

About

Avatar for wenzovic @wenzovic started