You are reading a single comment by @Jonny69 and its replies. Click here to read the full conversation.

  • the badge looks like aluminium - its a basic shield shape and has no paint or enamel so hopefully should tolerate bending quite well.
    pic shows the gap between badge and head tube i need to close -
    the head tube is 41mm diameter - how much smaller a tube should i bend it around do you think in order to close the gap in the pic? the downtube is 40mm...a candidate perhaps?

  • Put a bit of tape round the top tube or down tube to protect it and use that as your former 👍

About

Avatar for Jonny69 @Jonny69 started