You are reading a single comment by @Sam_w and its replies.
Click here to read the full conversation.
-
edit: what layer height is that? looks nice and low...!
Nice. Yes, I found the magnetic plate works really well when fully dialed in.
There are a few nice tool holders that use the screws on top, I particularly like the one that just holds the auto level.
I found that after a fair bit of use, my extruder was getting pretty noisy, so have just switched to an all metal micro-swiss one, its much smoother and quieter. Also have printed some better fan ducts, but have yet to install them yet.
Sam_w
Good. Took a little while to get a good dial in for the magnetic plate but it's printing really well at the moment.
Printed out a load of cable clips for my Festool vac / power lead recently and it's currently printing three battery clips and two tool clips for my tool wall.
No upgrades other than the magnetic mat. Need to print some sort of accessories holder though as it's all just laying around the place.