You are reading a single comment by @Airhead and its replies.
Click here to read the full conversation.
-
I often have to install taps that have that same setup (wall plate and tap that screws into it), and have the same problem but it’s much less of an issue as a temporary water supply on a building site.
My guesses would be using a nut as a lock ring like you suggest, or to get an oring/gasket that sits inside for it to tighten up against.
Nef
@Airhead
I'm struggling to come up with search terms for what I'm looking for to fix this sink tap. Not sure if just a nut on the thread would be enough to be able to align it or there's some other type of connection or tap that allows the tap to always be upright when the wall connection can't be altered.
1 Attachment