You are reading a single comment by @chiroshi and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Chak
dancing james
@chiroshi
Maybe not quite as porn worthy, but I just made myself a new small bearing press. 200mm trapezoidal thread 3D printer lead screw and nuts from ali express. I took some 1" brass hex bar and turned out two nuts which I pressed the original round 3D printer nuts into, and held in place with roll pins. The press dies for 6801 and 6802 are from BearingProTools, then I made myself an over axle kit for 6903 from acetate. Having access to a lathe is fun.
1 Attachment