You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.
  • Hey Tester
    If I was going to make this myself, would 7075 bar be suitable for this application? It's high strength as I understand but I know very little metallurgy

  • would 7075 bar be suitable for this application?

    Yes, for a solo 7075T6 is plenty strong enough. The tandem one is steel, but the Boost conversion on my 464 is 7075T6

    Plenty of boutique road rear hubs use 15mm 7075T6 axles, and converting a 15mm through bolt front hub you already have the bearing support tube doing the heavy lifting. I'd be pretty confident in a 6082T6 adapter made to that drawing, the 464 one is a different design with thinner walls.

About

Avatar for gbj_tester @gbj_tester started