You are reading a single comment by @pryally and its replies.
Click here to read the full conversation.
-
not the most exciting gate design and I've not got one of it installed (I should also have sloped the top member for the water to run off
2 Attachments
-
pryally
-
Nice work! I'm thinking something like the below, a chance to work on some mortice and tenon joinery. I might make it in some cheaper wood first off then think about getting fancy.
https://www.diy.com/departments/grange-timber-infill-gate-h-0-9m-w-0-9m/255269_BQ.prd
-
Are they plugs to cover screw holes or are they actual dowels?
stevo_com
Thanks, photos are always good to help convince the internal auditors.
Was looking at a low angle block as it goes, as I have a few jack planes already. Cheers.