You are reading a single comment by @andos and its replies.
Click here to read the full conversation.
-
Take more advice. Don’t trust mine!
-
Yeah this was my first instinct, the key things seem to be to identify the grain and only go with it in one direction, not even back and forth, and also that it's hard to do spot corrections, which is a massive downer.
-
I’d go at it with nylon pads on a die grinder, down through the grits. An elbow saver.
TGR
tyeness
Sharkstar
@andos
Maybe elbow grease is where I went wrong. I was quite hesitate to “go hard” as I didn’t want to make it worse.