You are reading a single comment by @jono84 and its replies.
Click here to read the full conversation.
-
What you want is sugru. Squish it into position on the back of the lever body and then leave to cure. Not sure if it sticks to alu though, so watch out you don't make it permanent, maybe some greaseproof paper in the gap or something.
-
I found the same problem on my old ones. I ran a small length of cable outer just round the bend and it helped a load.
-
I’d tuck in the bar tape in that area so you won’t get a lump.
Tenners
Chaley
edscoble
@jono84
Yeah sorry not the best description. This step highlighted below, i like thin tape and the back of the lever body is digging in something rotten when i ride on the hoods. Have padded it out with tape but it looks pretty bad. Wandering if something like Fimo would solve the issue.
1 Attachment