You are reading a single comment by @Jung and its replies.
Click here to read the full conversation.
-
No drama - twist up some bits of shop cloth and spray them with brake or carb cleaner and clean the threaded holes out. Make sure you use blue loctite - it takes a while to set so no problem there.
Watch it spraying carb or brake cleaner around - it'll go for plastic and paint.
@Airhead - looks proper!
Jung
Airhead
I’ve spent about an hour on the forums looking this up , it seems you should way reduce the torque if it has anti seize on it .
I’m guessing now I’ll go and buy a can of brake cleaner and with compressed air try and clean the bolts and bolt holes.
The BMW bolts that came out had loctite on so perhaps I should go with that and then torque them up .
Tbh I was a bit worried I’d not get them all done up before the loctite cured .
It all looks so simple , I watched a YouTube where a fella fits the very same bars and uses copious amounts of antisieze .I always thought it was good practice…. All I’ve done is create more work for myself .
Bugger