You are reading a single comment by @MCamb and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
MCamb
I need to replace the bearings on a Goldtec rear hub. I've done it once in the passed but managed to mess up the axle and destroy one of the new bearings, so I'd like to do a better job this time.
The main issue I had was pressing the new bearing in, the tolerances seem tighter than I'm used for bearings and the method I've used in the passed for my phil woods won't work as the axles are solid with the Goldtecs.
I'd like to get a cheap bearing driver kit £20/£25 tops but what should I get ? the concern I have is all the examples I've seen of a bearing driver being used are for hubs which don't need the axel in place when your fitting the second new bearing. So the driver needs to be able to clear the axel end and allow you to apply the pressure required to drive the bearing into place. Hopefully that makes sense ?
Does anybody have any advise / suggest of the best tools to buy ?