-
I have the larger version of that, the bits are unfortunately dogshit (esp the shiny masonry ones). I got the masonry only (still Bosch green, confusingly) set and they've been fine for any plaster/brick/block work. Don't ask me why they're different, maybe the big packs use lower spec ones for cost saving. But I would likely go for the pro ones mentioned up thread when I need to restock.
It might not be the same issue for stone, but one word of caution if you're going to use an SDS and start with a small pilot and work up the sizes. I did that to go through brick fitting an outside tap (started 8mm then 16mm). The 8mm went fine, but then the 16mm couldn't give two fucks which way the pilot hole was going and came out about 4" away from where the 8mm had gone!
I'd also use the depth stop for the first while until you get an idea of how easily it drills otherwise you could end up with a 6" deep hole putting up pictures..... ask me how I know....
You are reading a single comment by @stevo_com and its replies.
Click here to read the full conversation.
stevo_com
Gonna grab one, thanks! And some specific masonry bits that have good reviews