Home DIY

You are reading a single comment by @stevo_com and its replies. Click here to read the full conversation.

•

Bobbo in reply to @stevo_com

It's pretty shallow. Much deeper than that and you'll hear the unmistakable crackle and pop of a melted motor.

•

stevo_com in reply to @Bobbo

I used a circle cutting jig before with a less conservative depth of cut and I broke the 1/2" bit before the motor anywhere near bogged down.

Spend more if you want, but for 99% of what a DIY-er will do it's more than enough.

•

Bobbo in reply to @stevo_com

but for 99% of what a DIY-er will do it's more than enough.

Totally agree.

I just get frustrated when my expensive units cark it because I push them too hard (I supposed when I do that it's REALLY pushing them for 1hr+). But I can't take the chance with buying cheap ones.

About

Avatar for stevo_com @stevo_com started