You are reading a single comment by @Velocio and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Velocio
following on from my heat resistant cable chat above - I think I've decided to just drill through the bottom of my alcove cabinets, through the floor into the underbuilding below my living room and then route speaker cable below the floor and up into the cabinet on the other side of the alcove.
when I have routed the cable, what's the best way to then prevent drafts from the underbuilding ? I had thought about using expanding foam but that seems p.permanent and I might want to change the cables at some point I guess. it might be best to just run the cable through a narrow channel in the (not yet existent) underfloor insulation - that might eliminate drafts I guess