-
cheers - with the chamfer on the top its to clean up the edge where the laminate has chipped so I think will be 5mm at least - on the bottom edge i might do the same or go bigger to make a thinner edge profile - if it seems easy.
Re. radius - when you say lots of passes - i was thinking to make a template - trim excess with jigsaw close to the cut line and then use a flush trim bit with a bearing against the template. then remove template and bearing follows cut edge to get full depth cut - makey sense ?
Sheppz-
Yup, all of that makes sense. One pass for the top chamfer, maybe sneak up on the bottom one if it's deep.
Not sure I'd bother with the jigsawing, just go from the top down with the bearing bit. I have some handy templates if you'd like to borrow them.
dbr
1/4” will do both with lots of passes. How big is the chamfer?