I am a frame builder AMA

You are reading a single comment by @M_V and its replies. Click here to read the full conversation.

•

.gaz.

Do any of you frame-building folks have a fork crown knocking around in your workshop that I could buy and give to Winston?

For 1" steerer, with wide tyre clearance.. like this from Ceeway (unfortunately sold out for now). Doesn't have to be this exact one, just something similar:

•

M_V in reply to @.gaz.

I think I have a 1” version of the one Surly use on the steamroller fork, not quite as much clearance as that. Probably 50mm.

Any use?

•

.gaz. in reply to @M_V

Thanks @M_V : )
I think that might be just a tad too narrow but will check with Winston tomorrow and get back to you.

About

Avatar for M_V @M_V started