You are reading a single comment by @3c70 and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@3c70
Hey,
I've recently replaced the bearings and axle on my rear mavic ellipse but I'm having trouble working out how to put back the dust cap on the opposite side of the adjuster cap.
The cap is a little larger than the hub and I've just wrecked a new one trying to press fit it in. It actually started to push in but after about half way, it broke under the pressure.
Anyone done this before? It's an expensive mistake to make twice!
Thanks. Any advice is appreciated.