• I reckon your spokes will fit fine, providing they’re not completely poking through the nipple currently. My rough calcs are giving similar length on the drive side, and about 1mm less on the non-drive. Dubtap’s comment seems to suggest you need longer spokes, but the PCD is larger and the flange - centre measurement is about the same on the drive side, and a bit less on the non-drive side.

    If you do reuse your spokes, it’s a good idea to seperate the inbound and outbound spokes as you go, and relace them the same way in the new hub. The outbounds have been bent a little to angle in towards the rim.

  • My rough calcs

    Which include guesses on the spoke count and existing lacing, since the OP hasn't stated these 🙄

  • Which include guesses on the spoke count and existing lacing

    and spoke dia/stretch and a nominal erd to get an actual count. Yes of course. Nontheless, given the parts choice I’ve guessed at 3x 32spokes.

About

Avatar for gbj_tester @gbj_tester started