You are reading a single comment by @Jameo and its replies. Click here to read the full conversation.
  • 10spd (Centaur carbon groupset) shifter question if I may?
    When I drop the rear mech into the lowest (largest) cog, then try and shift up, the ratchet in the lever doesn't engage; so I end up having to tug the cable to get it to click up / engage.
    It happens whether I'm in the large or small front ring.
    Where's the problem likely to be? Cable tension, the mechanism in the shifter body, gremlins?
    Of course I should really just not use the 30t cog and htfu, but I'm tired and old.
    All suggestion welcome.

  • Sounds like the shifter ratchet is dead. A very common problem with 10spd when campag switched to cheap vinyl for the ratchet material. I’ve had to replace a veloce set for this reason. I think you can get it repaired if you have the time and willpower.

About

Avatar for Jameo @Jameo started