You are reading a single comment by @Sharkstar and its replies.
Click here to read the full conversation.
-
I wondered what kind of blade master you must be, cutting MDF strips out of sheet material and making such a success of it.
Sharkstar-
I only had to do a few where ms_com ordered too many 138mm wide strips and not enough 69mm wide ones. But luckily they were only 400mm long and using a knife means practically zero kerf. They did go well though. Careful with the first pass and semi-careful with the rest and it was grand. You do get a bit of a burr where the blade pushes a bit of material up but it's easily knocked off with a light sand.
stevo_com
Ordered the strips already cut to width. I didn't have to do 2m rip cuts thank god, just cutting to length