You are reading a single comment by @psg1ben and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
psg1ben
What in earth did you use to cut the bolt down?
Last time I did it-
Thread a nut on to the length you need.
Thread another nut on leaving enough gap for a junior hacksaw.
Cut using the nuts as a guide,
Theread off the nut on the side you need, which will neaten up the end.
Deburr the thread using a triangular file following the thread.
Came out straight, didn't cross thread.